Chinese-Simplified
Español 
Català 
Deutsch 
Português 
Français 
Italiano 
Turkish 
Czech 
English 
此气顶开发用于高压高速注塑产品。内部有停止块支撑注塑负荷，防止气顶阻塞。此气顶允许安装在斜角或非平面的表面（气顶表面可加工）。安装简易，附有调整垫，如果需要，允许重新安装。
Read moreShow less
Can I remove the valve from the tool?
Yes, on our catalogo page we indicate the size of the hole (E dimension) to be made before installing, the valve can then be removed using the appropiate ejector.
On the smaller diametres (6) extra care needs to be taken to remove the part slowly, knocking softly to avoid damage to the internal mechanisms.
On the smaller diametres (6) extra care needs to be taken to remove the part slowly, knocking softly to avoid damage to the internal mechanisms.
Is there any limitation on the position of the valves in the mold?
The valve should not be installed below the injection point. In that position the high temperatures and pressure could negatively influence the valve components and decrease their lifetime.
