Czech
Español 
Català 
Deutsch 
Português 
Français 
Italiano 
Turkish 
English 
Chinese-Simplified GS
GS.226616 can be used in 3-plate molds up to 500 x 500.
GS.368619 can be used in 3- plate molds up to 800 x 800.
GS.421024 can be used in 3- plate molds up to 1000 x 1000.
GS.368619 can be used in 3- plate molds up to 800 x 800.
GS.421024 can be used in 3- plate molds up to 1000 x 1000.
CUMSA recommends using 4 units in each mold, which are evenly spaced and symmetrical.
We don’t recommend it, the movement of the ejection plates is harsh and suffer a high load, due to all the mechanisms attached; contraction of the plastic parts, ejectors, lifters, stripper plates, etc. .. .
The maximum speed is 30 meters per minute.
It is essential that the leader pins are in the leader bushings before the GS closes. Please see technical drawing on catalogue page.
The surface level between all 3 different plates must be the same.
The surface level between all 3 different plates must be the same.
Yes, but the area where the screws and dowel pins are applied isn’t.
Yes, but these should be made by the customer.
